#Usb spi flash programmer serial#

#Usb spi flash programmer serial#

The target AVR microcontroller will enter Serial Programming mode only when its reset line is active (low). This is done by connecting ground of the target to ground of the programmer. The in-system programmer and target system need to operate with the same reference voltage.

Verify functions from the software screen.ДЄccording to the device information box from the software, signal connections should comply with the table below.ДЇollowing is an example pinout of SPI EEPROM:

Operate erase, blank check, and program.

Switch on the target board independent power supply.

Otherwise, VCC should be connected if power is supplied by the ISP cable.

It is recommended that the target board power is supplied independently, especially for target boards with high power consumption and multiple power systems.If the вЂњmass production' function is to be used, TPIN and TPOUT signal lines should also be connected.Connect signal lines (including GND) for corresponding interfaces of the ISP programmer with the target board.Search chip part numbers in the ISP programming software to view operation hint.The programming operation steps are as follows: User can erase, program, verify and read content of SPI EEPROM and Flash memory devices. The Serial Peripheral Interface (SPI) programmer (Superpro IS01 or Gang ISP programmer SuperPro IS03) provides fast programming of any SPI memory device by controlling the SPI bus signals directly through a dedicated high-speed SPI interface on the programmer. SuperPro IS01 Programmer supports high-speed programming of SPI compatible serial EEPROMs and Flash memory devices.